Pms (Property Management System); Port-Location Mapping; Pms Configuration - ZyXEL Communications Vantage Service Gateway VSG-1200 V2 User Manual

VSG-1200 V2 User's Guide
Table 20 System Settings: Billing: Billing Profile Setting (continued)
LABEL
Service Type
Reset
Apply

10.2 PMS (Property Management System)

Many hotels use a PMS device to perform in-room billing for services (such as room services,
mini-bar, pay-per-view TV or telephone) that the guests use.
With PMS, the VSG allows subscribers to purchase additional time units online. In addition,
subscribers can select from a number of different billing plans.
To use PMS for billing, first connect the VSG to a PMS device using the PMS port (refer to
Chapter 2 on page

10.2.1 Port-Location Mapping

When you activate port-location mapping and PMS on the VSG, two charge modes are
available: per room and per subscriber.
Select Based on Room when location is important. If a subscriber disconnects from one
location and reconnects in another location, the VSG prompts for the user name and password
again.
Select Based on Subscriber to allow a subscriber to freely move between different locations
without prompting for user name and password.

10.2.2 PMS Configuration

Click System Setting, Billing and click the PMS Configuration link to display the screen as
shown next.
91
DESCRIPTION
Select Private Service to set the VSG to assign private IP addresses to the
subscribers connected on the LAN.
Select Public Service to set the VSG to assign public IP addresses to the
subscribers connected on the LAN. You must have more than one public IP address
from your ISP.
Configure private and public DHCP IP address assignment in the Server screen.
Refer to Section 7.1.1 on page 70
Click Reset to restart configuring this screen again.
Click Apply to save the changes.
38), then configure the PMS settings on the VSG.
for more information.
Chapter 10 Billing