Lan Configuration; Figure 169 Smt: Lan Configuration; Table 77 Smt: Lan Configuration - ZyXEL Communications Vantage Service Gateway VSG-1200 V2 User Manual

Table 76 SMT: WAN Configuration: PPTP (continued)
FIELD
TCP MSS Setting
At the "S)ave and return R)eturn without saving M)odify:" prompt, type S and press [ENTER] to save the
changes and return to the previous screen, type R and press [ENTER] to discard all changes and return
to the previous screen or type M and press [ENTER] to continue configuring the fields. Restart the
device when prompted
Press [ESC] and enter Y to stop any actions in the current screen and return to the previous screen. All
changes will be discarded.

32.7 LAN Configuration

From the Main Menu screen, enter 3 to display the LAN Configuration menu as shown next.
Refer to Chapter 6 on page 60

Figure 169 SMT: LAN Configuration

DHCP Configuration
DHCP Service? (D/R/S)
Start IP Address(Private) :10.59.1.2
DHCP Pool Size
Lease Time
Primary DNS IP Address
Secondary DNS IP Address
The following table describes the fields in this menu.

Table 77 SMT: LAN Configuration

FIELD
DHCP Service?
(D/R/S)
Start IP Address
DHCP Pool Size
Lease Time
Chapter 32 Using The SMT
DESCRIPTION
Enter the size of the Maximum Segment Size (MSS).
for background information.
LAN Configuration
:S
(Private) :20
(Private) :1440
:168.95.1.1
:
DESCRIPTION
Enter D (Disable) to deactivate DHCP services on the LAN. Ethernet devices
connected to the LAN interface must use static IP addresses.
Enter R (Relay) to set the VSG to forward network configuration requests to a
DHCP server on the LAN network. Then configure the Server IP Address and
Agent IP Address fields.
Enter S (Server) to set the VSG to assign network information (IP address, DNS
information etc.) to Ethernet device(s) connected to the LAN port. This is the
default setting.
This field is visible when you enter S in the DHCP Service field.
Enter the first of the continuous addresses in the IP address pool. The default is
10.59.1.2.
This field is visible when you enter S in the DHCP Service field.
This field specifies the size or count of the IP address pool. Enter a number not
greater than 1024. The default is 253.
This field is visible when you enter S in the DHCP Service field.
Specify the time (in minutes between 1 and 71582788) a DHCP client is allowed to
use an assigned IP address. When the lease time expires, the DHCP client is
given a new, unused IP address. The default is 1440 minutes.
VSG-1200 V2 User's Guide
222