Applying An Ip Policy; Ethernet Ip Policies - ZyXEL Communications Prestige 662H Series User Manual

Table 147 Menu 25.1.1 IP Routing Policy (continued)
FIELD
Gateway addr
Type of Service
Precedence
Log
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

43.5 Applying an IP Policy

This section shows you where to apply the IP policies after you design them.

43.5.1 Ethernet IP Policies

From Menu 3 — Ethernet Setup, type 2 to go to Menu 3.2 — TCP/IP and DHCP Ethernet
Setup.
You can choose up to four IP policy sets (from 12) by typing their numbers separated by
commas, for example, 2, 4, 7, 9.
Chapter 43 IP Policy Routing
DESCRIPTION
Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it is on the LAN, otherwise, the gateway must be the IP
address of a remote node. The default gateway is specified as 0.0.0.0.
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic
by choosing No Change, Normal, Min Delay, Max Thruput, Max Reliable or
Min Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or No
Change.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
" to save your configuration, or press [ESC] at any time to cancel.
Prestige 662H/HW Series User's Guide
Press ENTER to Confirm
426