Traffic Redirect Setup; Figure 151 Menu 2 Wan Backup Setup; Figure 152 Menu 2.1Traffic Redirect Setup; Table 105 Menu 2.1Traffic Redirect Setup - ZyXEL Communications Prestige 662H Series User Manual

Prestige 662H/HW Series User's Guide
Table 104 Menu 2 WAN Backup Setup (continued)
FIELD
KeepAlive Fail
Tolerance
Recovery Interval(sec) When the Prestige is using a lower priority connection (usually a WAN backup
ICMP Timeout
Traffic Redirect
Dial Backup
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

27.2.1 Traffic Redirect Setup

Configure parameters that determine when the Prestige will forward WAN traffic to the
backup gateway using Menu 2.1 — Traffic Redirect Setup.

Figure 152 Menu 2.1Traffic Redirect Setup

The following table describes the fields in this menu.

Table 105 Menu 2.1Traffic Redirect Setup

FIELD
Active.
Configuration
Backup Gateway
IP Address
307
DESCRIPTION
Type the number of times (2 recommended) that your Prestige may ping the IP
addresses configured in the Check WAN IP Address field without getting a
response before switching to a WAN backup connection (or a different WAN
backup connection).
connection), it periodically checks to whether or not it can use a higher priority
connection.
Type the number of seconds (30 recommended) for the Prestige to wait
between checks. Allow more time if your destination IP address handles lots of
traffic.
Type the number of seconds for an ICMP session to wait for the ICMP
response
Press [SPACE BAR] to select Yes or No.
Select Yes and press [ENTER] to configure Menu 2.1 Traffic Redirect Setup.
Select No (default) if you do not want to configure this feature.
Press [SPACE BAR] to select Yes or No.
Select Yes and press [ENTER] to configure Menu 2.2 Dial Backup Setup.
Select No (default) if you do not want to configure this feature.
" to save your configuration, or press [ESC] at any time to cancel.
Menu 2.1 - Traffic Redirect Setup
Active= No
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 15
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic redirect
setup. The default is No
Enter the IP address of your backup gateway in dotted decimal notation.
The Prestige automatically forwards traffic to this IP address if the Prestige's
Internet connection terminates.
Press ENTER to Confirm
Chapter 27 Menu 2 WAN Backup Setup