Applying An Ip Policy; Ethernet Ip Policies - ZyXEL Communications P-660H-D Series User Manual

Table 108 Menu 25.1.1 IP Routing Policy (continued)
FIELD
Gateway type
Gateway addr
Gateway node
Type of Service
Precedence
Log
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

34.5 Applying an IP Policy

This section shows you where to apply the IP policies after you design them.

34.5.1 Ethernet IP Policies

From Menu 3 - Ethernet Setup, type 2 to go to Menu 3.2 - TCP/IP and DHCP Ethernet
Setup.
You can choose up to four IP policy sets (from 12) by typing their numbers separated by
commas, for example, 2, 4, 7, 9.
Chapter 34 IP Policy Routing
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select Gateway addr and enter the
IP address of the gateway if you want to specify the IP address of the gateway.
The gateway must be a router on the same segment as your Prestige's LAN or
WAN port.
Press [SPACE BAR] and then [ENTER] to select Gateway node to have the
Prestige send traffic that matches the policy route through a specific remote
node.
If you selected Gateway addr in the Gateway type field, defines the outgoing
gateway address here. The gateway must be on the same subnet as the
Prestige if it is on the LAN, otherwise, the gateway must be the IP address of a
remote node. The default gateway is specified as 0.0.0.0.
If you selected Gateway node in the Gateway type field, enter the index
number of a remote node you configured in menu 11.
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic
by choosing No Change, Normal, Min Delay, Max Thruput, Max Reliable or
Min Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or No
Change.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
" to save your configuration, or press [ESC] at any time to cancel.
P-660R/H-D Series User's Guide
Press ENTER to Confirm
302