Table 74 Vpn: Manual Key - ZyXEL Communications Prestige 662H Series User Manual

Table 74 VPN: Manual Key

LABEL
IPSec Setup
Active
Name
IPSec Key Mode
SPI
Encapsulation
Mode
DNS Server (for
IPSec VPN)
Local
Local Address Type Use the drop-down menu to choose Single, Range, or Subnet. Select Single for
IP Address Start
End / Subnet Mask When the Local Address Type field is configured to Single, this field is N/A.
Remote
Remote Address
Type
IP Address Start
Chapter 19 VPN Screens
DESCRIPTION
Select this check box to activate this VPN policy.
Type up to 32 characters to identify this VPN policy. You may use any character,
including spaces, but the Prestige drops trailing spaces.
Select IKE or Manual from the drop-down list box. Manual is a useful option for
troubleshooting if you have problems using IKE key management.
Type a number (base 10) from 1 to 999999 for the Security Parameter Index.
Select Tunnel mode or Transport mode from the drop-down list box.
If there is a private DNS server that services the VPN, type its IP address here.
The Prestige assigns this additional DNS server to the Prestige 's DHCP clients
that have IP addresses in this IPSec rule's range of local addresses.
A DNS server allows clients on the VPN to find other computers and servers on
the VPN by their (private) domain names.
Local IP addresses must be static and correspond to the remote IPSec router's
configured remote IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You
can configure multiple SAs between the same local and remote IP addresses, as
long as only one is active at any time.
a single IP address. Select Range for a specific range of IP addresses. Select
Subnet to specify IP addresses on a network by their subnet mask.
When the Local Address Type field is configured to Single, enter a (static) IP
address on the LAN behind your Prestige. When the Local Address Type field is
configured to Range, enter the beginning (static) IP address, in a range of
computers on your LAN behind your Prestige. When the Local Address Type
field is configured to Subnet, this is a (static) IP address on the LAN behind your
Prestige.
When the Local Address Type field is configured to Range, enter the end (static)
IP address, in a range of computers on the LAN behind your Prestige. When the
Local Address Type field is configured to Subnet, this is a subnet mask on the
LAN behind your Prestige.
Remote IP addresses must be static and correspond to the remote IPSec router's
configured local IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You
can configure multiple SAs between the same local and remote IP addresses, as
long as only one is active at any time.
Use the drop-down menu to choose Single, Range, or Subnet. Select Single
with a single IP address. Select Range for a specific range of IP addresses.
Select Subnet to specify IP addresses on a network by their subnet mask.
When the Remote Address Type field is configured to Single, enter a (static) IP
address on the network behind the remote IPSec router. When the Remote
Address Type field is configured to Range, enter the beginning (static) IP
address, in a range of computers on the network behind the remote IPSec router.
When the Remote Address Type field is configured to Subnet, enter a (static) IP
address on the network behind the remote IPSec router.
Prestige 662H/HW Series User's Guide
238