Log Commands; Configuring What You Want The Prestige To Log; Figure 41 Displaying Log Categories Example; Figure 42 Displaying Log Parameters Example - ZyXEL Communications Prestige 662H Series User Manual

Table 47 RFC-2408 ISAKMP Payload Types (continued)
LOG DISPLAY
SIG
NONCE
NOTFY
DEL
VID

Log Commands

Go to the command interpreter interface
commands).

Configuring What You Want the Prestige to Log

1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the Prestige is to record.
2 Use sys logs category to view a list of the log categories.

Figure 41 Displaying Log Categories Example

Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
wan
wlan
bridge
radius
ras>
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.

Figure 42 Displaying Log Parameters Example

ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both]
ras>
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Appendix S
PAYLOAD TYPE
Signature
Nonce
Notification
Delete
Vendor ID
(Appendix N
exit device
poe aux
ip ipsec
hdap bm
8021x
Prestige 662H/HW Series User's Guide
explains how to access and use the
ether
config
ppp
lan
552