Outgoing Authentication Protocol - ZyXEL Communications Prestige 662H Series User Manual

Prestige 662H/HW Series User's Guide
Table 115 Menu 11.1 Remote Node Profile (continued)
FIELD
Route
Bridge
Edit IP/Bridge
Edit ATM Options
Edit Advance
Options
Telco Option
Allocated Budget
(min)
Period (hr)
Schedule Sets
Nailed up
Connection
Session Options
Edit Filter Sets
Idle Timeout (sec)
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

31.2.3 Outgoing Authentication Protocol

For obvious reasons, you should employ the strongest authentication protocol possible.
However, some vendors' implementation includes specific authentication protocol in the user
profile. It will disconnect if the negotiated protocol is different from that in the user profile,
even when the negotiated protocol is stronger than specified. If the peer disconnects right after
a successful authentication, make sure that you specify the correct authentication protocol
when connecting to such an implementation.
329
DESCRIPTION
PAP – accept PAP (Password Authentication Protocol) only.
This field determines the protocol used in routing. Options are IP and None.
When bridging is enabled, your Prestige will forward any packet that it does not
route to this remote node; otherwise, the packets are discarded. Select Yes to
enable and No to disable.
Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.3 –
Remote Node Network Layer Options.
Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.6 –
Remote Node ATM Layer Options.
This field is only available when you select PPPoE in the Encapsulation field.
Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.8 –
Advance Setup Options.
This sets a ceiling for outgoing call time for this remote node. The default for this
field is 0 meaning no budget control.
This field is the time period that the budget should be reset. For example, if we
are allowed to call this remote node for a maximum of 10 minutes every hour,
then the Allocated Budget is (10 minutes) and the Period (hr) is 1 (hour).
This field is only applicable for PPPoE and PPPoA encapsulation. You can apply
up to four schedule sets here. For more details please refer to
Scheduling .
This field is only applicable for PPPoE and PPPoA encapsulation. This field
specifies if you want to make the connection to this remote node a nailed-up
connection. More details are given earlier in this section.
Use [SPACE BAR] to choose Yes and press [ENTER] to open menu 11.5 to edit
the filter sets. See the Remote Node Filter section for more details.
Type the number of seconds (0-9999) that can elapse when the Prestige is idle
(there is no traffic going to the remote node), before the Prestige automatically
disconnects the remote node. 0 means that the session will not timeout.
" to save your configuration, or press [ESC] at any time to cancel.
Chapter 44 Call
Press ENTER to Confirm
Chapter 31 Remote Node Configuration