My Wan Addr Sample Ip Addresses - ZyXEL Communications Prestige 662H Series User Manual

Prestige 662H/HW Series User's Guide
Table 116 Menu 11.3 Remote Node Network Layer Options (continued)
FIELD
Address
Mapping Set
Metric
Private
RIP Direction
Version
Multicast
IP Policies
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

31.3.1 My WAN Addr Sample IP Addresses

The following figure uses sample IP addresses to help you understand the field of My WAN
Addr in menu 11.3. Refer to the previous
setup for a brief review of what a WAN IP is. My WAN Addr indicates the local Prestige
WAN IP (172.16.0.1 in the following figure) while Rem IP Addr indicates the peer WAN IP
(172.16.0.2 in the following figure).
331
DESCRIPTION
When Full Feature is selected in the NAT field, configure address mapping sets in
menu 15.1. Select one of the NAT server sets (2-10) in menu 15.2 (see
Network Address Translation (NAT)
When SUA Only is selected in the NAT field, the SMT uses NAT server set 1 in menu
15.2 (see Chapter 34 Network Address Translation (NAT)
The metric represents the cost of transmission for routing purposes. IP routing uses
hop count as the cost measurement, with a minimum of 1 for directly connected
networks. Type a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
This determines if the Prestige will include the route to this remote node in its RIP
broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast.
If No, the route to this remote node will be propagated to other hosts through RIP
broadcasts.
Press [SPACE BAR] and then [ENTER] to select the RIP Direction. Options are
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are RIP-1,
RIP-2B or RIP-2M.
IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and None disables
IGMP.
You can apply up to four IP Policy sets (from 12) by typing in their numbers separated
by commas. Configure the filter sets in menu 25 first (see
Routing ) and then apply them here.
" to save your configuration, or press [ESC] at any time to cancel.
for details) and type that number here.
Press ENTER to Confirm
Figure 19 in the web configurator chapter on LAN
Chapter 31 Remote Node Configuration
Chapter 34
for details).
Chapter 43 IP Policy