Editing Atm Layer Options; Vc-Based Multiplexing (Non-Ppp Encapsulation); Figure 169 Menu 11.5 Remote Node Filter (Rfc 1483 Or Enet Encapsulation); Figure 170 Menu 11.5 Remote Node Filter (Pppoa Or Pppoe Encapsulation) - ZyXEL Communications Prestige 662H Series User Manual

Prestige 662H/HW Series User's Guide

Figure 169 Menu 11.5 Remote Node Filter (RFC 1483 or ENET Encapsulation)

Figure 170 Menu 11.5 Remote Node Filter (PPPoA or PPPoE Encapsulation)

31.5 Editing ATM Layer Options

Follow the steps shown next to edit Menu 11.6 – Remote Node ATM Layer Options.
In menu 11.1, move the cursor to the Edit ATM Options field and then press [SPACE BAR]
to select Yes. Press [ENTER] to display Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of menu 11.6 for the Prestige, depending on whether you chose VC-
based/LLC-based multiplexing and PPP encapsulation in menu 11.1.

31.5.1 VC-based Multiplexing (non-PPP Encapsulation)

For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual
circuit, for example, VC1 will carry IP. Separate VPI and VCI numbers must be specified for
each protocol.
333
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Chapter 31 Remote Node Configuration