Configuring Attack Alert; Figure 70 Firewall: Anti Probing; Table 49 Firewall: Anti Probing - ZyXEL Communications Prestige 662H Series User Manual

Figure 70 Firewall: Anti Probing

The following table describes the labels in this screen.

Table 49 Firewall: Anti Probing

LABEL
Respond to PING
on
Do not respond to
requests for
unauthorized
services.
Back
Apply
Reset

14.12 Configuring Attack Alert

Attack alerts are the first defense against DOS attacks. In the Threshold screen, shown later,
you may choose to generate an alert whenever an attack is detected. For DoS attacks, the
Prestige uses thresholds to determine when to drop sessions that do not become fully
established. These thresholds apply globally to all sessions.
You can use the default threshold values, or you can change them to values more suitable to
your security requirements.
Chapter 14 Firewall Configuration
DESCRIPTION
The Prestige does not respond to any incoming Ping requests when Disable is
selected.
Select LAN to reply to incoming LAN Ping requests.
Select WAN to reply to incoming WAN Ping requests.
Select DMZ to reply to incoming DMZ Ping requests.
Otherwise select LAN & WAN & DMZ to reply to both incoming LAN and WAN
and DMZ Ping requests.
Select this option to prevent hackers from finding the Prestige by probing for
unused ports. If you select this option, the Prestige will not respond to port
request(s) for unused ports, thus leaving the unused ports and the Prestige
unseen. By default this option is not selected and the Prestige will reply with an
ICMP Port Unreachable packet for a port probe on its unused UDP ports, and a
TCP Reset packet for a port probe on its unused TCP ports.
Note that the probing packets must first traverse the Prestige 's firewall
mechanism before reaching this anti-probing mechanism. Therefore if the firewall
mechanism blocks a probing packet, the Prestige reacts based on the firewall
policy, which by default, is to send a TCP reset packet for a blocked TCP packet.
You can use the command "sys firewall tcprst rst [on|off]" to change this policy.
When the firewall mechanism blocks a UDP packet, it drops the packet without
sending a response packet.
Click Back to return to the previous screen.
Click Apply to save your changes back to the Prestige.
Click Reset to begin configuring this screen afresh.
Prestige 662H/HW Series User's Guide
176