33.2.2 Bridge Static Route Setup
Similar to network layer static routes, a bridging static route tells the Prestige the route to a
node before a connection is established. You configure bridge static routes in menu 12.3.1 (go
to menu 12, choose option 3, then choose a static route to edit) as shown next.
Figure 181 Menu 12.3.1 Edit Bridge Static Route
The following table describes the Edit Bridge Static Route menu.
Table 120 Menu 12.3.1 Edit Bridge Static Route
FIELD
Route #
Route Name
Active
Ether Address
IP Address
Gateway Node
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:
Chapter 33 Bridging Setup
Menu 12.3.1 - Edit Bridge Static Route
Route #: 1
Route Name=
Active= No
Ether Address= ?
IP Address=
Gateway Node= 1
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
This is the route index number you typed in Menu 12.3 – Bridge Static Route Setup.
Type a name for the bridge static route for identification purposes.
Indicates whether the static route is active (Yes) or not (No).
Type the MAC address of the destination computer that you want to bridge the
packets to.
If available, type the IP address of the destination computer that you want to bridge
the packets to.
Press [SPACE BAR] and then [ENTER] to select the number of the remote node (one
to eight) that is the gateway of this static route.
" to save your configuration, or press [ESC] at any time to cancel.
Prestige 662H/HW Series User's Guide
Press ENTER to Confirm
342