Honda WB20XT2 Manual page 92

dummyhead dummyhead
IMPELLER/END PLATE REMOVAL/INSTALLATION
Remove the casing
ADJUSTER SHIM
WB30XT3: CASING COVER
(page 10-3).
WB20XT3: CASING COVER
FLOATING SEAT
INSTALLATION:
Check the seat surface for damage, nicks.
Apply soapy water to the rubber ring and
install the floating seat in the rubber ring.
Push the rubber ring and the floating seat into
the impeller by finger pressure.
After installing, check to be sure the seat and
rubber ring are fully seated and are not tilted.
IMPELLER
REMOVAL:
Hold the flywheel [1] with a
commercially available strap
wrench [2], being careful not to
damage the magnet part [3].
Remove the impeller.
[2]
[1]
SEALING WASHER (4)
BOLT (8 x 28 mm) (4)
RUBBER RING
INSTALLATION:
Hold the flywheel [1] with a commercially
available strap wrench [2], being careful
not to damage the magnet part [3].
Tighten the impeller to the specified torque.
25 N·m (2.5 kgf·m, 18 lbf·ft)
After installation, check the impeller clearance
( page 3-2 ).
[3]
[2]
[1]
[3]
10-5