Honda WB20XT2 Manual page 61

dummyhead dummyhead
GOVERNOR SYSTEM
GOVERNOR ARM/CONTROL BASE
GOVERNOR SYSTEM
REMOVAL/INSTALLATION
Remove the following:
– Air cleaner (page 6-5)
– Fuel tank (page 6-3)
After installation, adjust the following:
– Governor (page 7-4)
– Idle speed (page 3-6)
– Maximum speed (page 7-6)
GOVERNOR SPRING
INSTALLATION:
Hook the governor spring to the
appropriate hole on the control lever
as shown.
WB20XT2
WB30XT2
BOLT
WB20XT2: (6 x 20 mm)
WB30XT2: (6 x 12 mm)
CONTROL BASE
7-2
GOVERNOR ARM BOLT
BOLT (6 x 12 mm)
WB20XT2•WB30XT2
NUT (6 mm)
INSTALLATION:
Tighten the nut and then
make sure that the clearance
is normal as shown.
More than 0.5 mm (0.02 in)
GOVERNOR ARM
GOVERNOR ROD/
THROTTLE RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor to a point where
the groove (1) of the throttle arm
lines up with the governor rod (2)
and then lift the governor rod out of
the hole of the throttle arm and
unhook the throttle return spring (3).
(2)
(1)
(3)