Honda WB20XT2 Manual page 79

dummyhead dummyhead
STARTING SYSTEM
ASSEMBLY
Pass the recoil starter rope (1) through the hole (2) of
the recoil starter pulley (3), and then tie the rope as
shown.
Wind the recoil starter rope onto the recoil starter pulley
counterclockwise as shown.
Hook the outer hook (1) of the starter return spring (2)
to the groove (3) of the recoil starter pulley (4), and then
install the starter return spring by winding it.
Apply grease to the starter pulley sliding surface (1) of
the recoil starter case (2).
Set the recoil starter pulley (3) to the recoil starter case
by aligning the inner hook (4) of the starter return spring
with the boss (5) of the recoil starter case as shown.
Apply grease to the ratchets (1).
Install the ratchet springs (2) and ratchets to the recoil
starter pulley (3) as shown.
9-4
WB20XT2•WB30XT2
(2)
(3)
(2)
(4)
(3)
(1)
(2)
(1) (1)
(2) (3)
(1)
(3) (1)
(4)
(5)
(2)