Honda WBK 30 Owner's Manual
  1. Manuals
  2. Brands
  3. Honda Manuals
  4. Water Pump
  5. WBK 30
  6. Owner's manual

Honda WBK 30 Owner's Manual

Pumpset
Hide thumbs
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Related Manuals for Honda WBK 30

Summary of Contents for Honda WBK 30

  • Page 3 xz k gd iq f Lrdk...
  • Page 4 The information and specifications included in this publication were in effect at the time of approval for printing. Honda Siel Power Products Ltd. reserves the right, however, to discontinue or change specifications or design at any time without notice and without incurring any obligation whatsoever.
  • Page 5 INTRODUCTION Congratulations on your selection of a Honda Portable Pumpset. We are certain you will be pleased with your purchase of one of the finest pumpset in the market. We want to help you get the best results from your new pumpset and to operate it safely.
  • Page 6 A FEW WORDS ABOUT SAFETY Your safety and the safety of others are very important. And using this Pumpset safely is an important responsibility. To help you make informed decisions about safety, we have provided operating procedures and other information on labels and in this manual. This information alerts you to potential hazards that could hurt you or others.

  • Page 7: Table Of Contents

    CONTENTS PUMPSET SAFETY ............... SAFETY INSTRUCTIONS ............COMPONENT IDENTIFICATION ..........PRE-OPERATION CHECK ............OPERATION 10-13 ................... SERVICING YOUR PUMPSET ............ 14-16 TRANSPORTING & STORAGE ..........TROUBLE SHOOTING 18-19 ..............TECHNICAL INFORMATION 20-23 ............WARRANTY POLICY ..............INSTALLATION & FREE SERVICES .........

  • Page 8: Pumpset Safety

    PUMPSET SAFETY IMPORTANT SAFETY INFORMATION Most accidents with pumpset can be prevented if you follow all instructions in this manual and on the pumpset. Some of the most common hazards are discussed below, along with the best way to protect yourself and others. Operator Responsibility •...

  • Page 9: Safety Instructions

    ADEQUATE VENTILATION WHILE PUMPSET OPERATION. Honda pumpset is designed to give safe and dependable service if operated according to instructions. Read and understand the Owner’s Manual before operating the pumpset. Failure to do so could result in personal injury or equipment damage.

  • Page 10: Component Identification

    COMPONENT IDENTIFICATION THROTTLE LEVER ENGINE OIL DRAIN BOLT DRAIN COCK CHOKE ROD AIR CLEANER PETROL TANK CAP KEROSENE TANK CAP FUEL COCK ENGINE OIL FILLER CAP ENGINE SWITCH PRIMING WATER FILLER CAP DISCHARGE PORT SUCTION PORT PUMP DRAIN PLUG MUFFLER STRAINER...

  • Page 11: Pre-Operation Check

    PRE-OPERATION CHECK Always check the following items before you start the pumpset. Check the General Condition of the Pumpset. 1. Look around and underneath the pumpset for signs of oil or petrol leaks. 2. Remove any excessive dirt or debris, especially around the muffler and recoil starter. 3.
  • Page 12 PRE-OPERATION CHECK 2. FUEL LEVEL 1. Check the fuel level. If the fuel level is low, f ill to the shoulder of the fuel filter. Never use an oil / petrol mixture or dirty Petrol / Kerosene. CAUTION 3. AIR CLEANER 1.

  • Page 13: Pre-Operation Check

    PRE-OPERATION CHECK 4. PUMP 1. Connect the suction hose. SUCTION HOSE CAUTION Always use the strainer with the suction hose as gravel or debris sucked into the HOSE BAND pump will cause serious impeller damage. Ensure proper clamping with band hose. STRAINER 2.

  • Page 14: Operation

    OPERATION STARTING THE ENGINE COLD STARTING (For WBK 30 & WPK 20) 6. Raise the throttle lever slightly. 1. Turn the engine switch to the “ON” position. NOTE : Ensure priming water before starting. 2. Pull the choke rod .
  • Page 15 OPERATION STARTING THE ENGINE COLD STARTING (For WB 30 & WP 20) 4. Raise the throttle lever slightly. 1. Turn the engine switch to the “ON” position. NOTE : Ensure priming water before starting. 2. Pull the choke rod to ‘CLOSE’. 5.
  • Page 16 OPERATION STARTING THE ENGINE HOT STARTING (For WBK 30 & WPK 20) 1. Turn the engine switch to the “ON” position. 5. Turn the fuel cock to the ‘START’. 6. Raise the throttle lever slightly. 2. Ensure the choke is in ‘OPEN’ position.

  • Page 17: Stopping The Engine

    OPERATION STARTING THE ENGINE STOPPING THE ENGINE HOT STARTING (For WB 30 & WP 20) To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal conditions, 1. Turn the engine switch to the “ON” position. use the following procedure.

  • Page 18: Servicing Your Pumpset

    (2) These items should be serviced by your servicing dealer, unless you have the proper tools and are mechanically proficient. Refer to Honda shop manual for service procedure. (3) For commercial use, log hours of operation to determine proper maintenance intervals.

  • Page 19: Air Cleaner

    SERVICING YOUR PUMPSET AIR CLEANER Cleaning Oil Bath Type 1. Remove the wing nut, and remove the air cleaner cap and cover. 2. Remove the air filter element from the cover. (A) Wash the cover and filter element in warm soapy water (B) Rinse and allow to dry thoroughly, or clean in non-flammable solvent and allow to dry.
  • Page 20 SERVICING YOUR PUMPSET SPARK PLUG 1. Remove the spark plug. 2. Clean the deposit. 0.6 – 0.7 mm (0.024 – 0.027 in) 3. Measure the clearance. A loose spark plug can overheat and damage the engine. Over tightening the spark plug can damage the threads in the cylinderhead.

  • Page 21: Transporting & Storage

    Reinstall the fuel strainer and the fuel tank cap. 3. Drain the fuel Place a suitable container under the drain tube. In WBK 30 and WPK 20 - Turn the fuel cock to the ‘START’ position. Open the drain cock and drain the Petrol from the carburetor.

  • Page 22: Troubleshooting

    Start engine with throttle lever in MAX. position. Fuel filter restricted Replace or repair faulty Take pumpset to an carburetor malfunction, components as necessary. authorized Honda ignition malfunction, servicing dealer, or refer to shop manual valve stuck, etc. ENGINE LACKS POWER POSSIBLE CAUSE CORRECTION 1.
  • Page 23 TROUBLESHOOTING When the pumpset cannot pump the water 2. Is the strainer clogged ? 1. Is the pump fully primed ? 5. Is the suction head too high ? 3. Are the hose band installed securely ? 4. Are the hose damaged ? 6.

  • Page 24: Technical Information

    TECHNICAL INFORMATION Model Pumpset WBK30 WB30 WPK20 WP20 Full frame 623 x 490 x 498 540 x 440 x 476 Dimensions (L x W x H in mm) Carry Handle 603 x 490 x 487 515 x 440 x 487 Centrifugal Self Priming, Monoblock Horizontal Type with Mechanical seal...
  • Page 25 TECHNICAL INFORMATION PERFORMANCE CURVE WBK 30 / WB 30 100 200 300 400 500 600 700 800 900 1000 1100 DISCHARGE (Ltr/Min.)
  • Page 26 TECHNICAL INFORMATION PERFORMANCE CURVE WPK 20 100 200 300 400 500 600 700 800 900 1000 1100 DISCHARGE (Ltr/Min.)

  • Page 27: Technical Information

    TECHNICAL INFORMATION PERFORMANCE CURVE WP 20 100 200 300 400 500 600 700 800 900 1000 1100 DISCHARGE (Ltr/Min.)

  • Page 28: Warranty Policy

    INSTALLATION AND FREE SERVICES 1. PRE-DELIVERY INSPECTION (P.D.I.) A pre delivery inspection is provided by Honda Authorised dealer so that you can enjoy longer trouble free PUMPSET life. P.D.I. coupon is attached herewith. 2. PERIODIC MAINTENANCE SERVICE To enhance trouble free Pumpset life, periodic maintenance must be carried out as per maintenance schedule given in the owner's manual.
  • Page 29 A-904, Siddhi Vinayak Tower, B/H DCP Office, Off S.G. Highway, Makarba, Ahmedabad-380051, Gujarat. Tel. : 079-48000730, 9978912986 : 079-29700121 E-mail : ao.ahm@hspp.com Door No.1-8-32/64, Plot No.64, G. Y. R. Plaza, IInd Floor, Bapu Bagh Colony, P. G. Road, Secunderabad - 500 003, Telangana. Tel.

  • Page 30: List Of Area Offices

    (Book Counter) PRE - DELIVERY INSPECTION(P.D.I.) SERVICE A P.D.I. Dealer's Stamp P.D.I. Date Frame No. Warranty lapses on: Servicing Dealer's Stamp: Model Engine No. Service Date: Cumm. Oper. Hours Purpose To be availed within 100 operation PRE - DELIVERY INSPECTION SERVICE hours or 180 days from the date of (P.D.I.)
  • Page 31 Operations Operations hange engine oil with YES NO Check for Engine / Model No. Not OK recommended grade. & tally with documents. Clean air cleaner element. YES NO Check for damage during transit. Clean spark plug & adjust if Adjustment required.
  • Page 32 (Book Counter) PRE - DELIVERY INSPECTION(P.D.I.) SERVICE A P.D.I. Dealer's Stamp P.D.I. Date Frame No. Warranty lapses on: Servicing Dealer's Stamp: Model Engine No. Service Date: Cumm. Oper. Hours Purpose To be availed within 100 operation PRE - DELIVERY INSPECTION SERVICE hours or 180 days from the date of (P.D.I.)
  • Page 33 Operations Operations hange engine oil with YES NO Check for Engine / Model No. Not OK recommended grade. & tally with documents. Clean air cleaner element. YES NO Check for damage during transit. Clean spark plug & adjust if Adjustment required.
  • Page 34 Observe the local laws or regulations or consult your authorized Honda dealer to dispose of these parts. Please dispose of used engine oil in a manner that is compatible with the environment.
  • Page 35 Honda Siel Power Products Limited To access information about Regd. Off. : 409, DLF Tower B, Operations, Maintenance & Jasola Commercial Complex, New Delhi -110 025. Troubleshooting, please visit: : L40103DL2004PLC203950 www.hppsv.com/IND/ or scan E-mail ho.mgt@hspp.com www.hondasielpower.com Website 1800 11 2323 Tel.

This manual is also suitable for:

Wb 30Wpk 20Wp 20

Table of Contents