Honda WB20XT2 Manual page 55

dummyhead dummyhead
FUEL SYSTEM
CARBURETOR
REMOVAL/INSTALLATION
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Remove the air cleaner (page 6-5).
Set a commercially available tube clamp HCP6A on the
fuel tube.
Loosen the drain screw of the carburetor to drain the fuel completely (page 6-3).
FUEL TUBE
TUBE CLIP
CARBURETOR INSULATOR
INSTALLATION:
Before installing, clean the passage (1) thoroughly with compressed air.
Install the carburetor insulator with the vent groove facing toward the
carburetor.
After installing, clamp the high-tension cord (2) and fuel tube (3) to the
carburetor insulator.
WB20XT2:
(2)
(1)
6-6
INSULATOR PACKING
WB30XT2:
(2)
(3)
(1)
WB20XT2•WB30XT2
GOVERNOR ROD/ THROTTLE RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor to a point where the groove (1) of
the throttle arm lines up with the governor rod (2),
and then lift the governor rod out of the hole of the
throttle arm and unhook the throttle return spring (3).
(2)
(1)
HCP6A (Commercially available)
CARBURETOR PACKING
CARBURETOR
(3)
DRAIN SCREW