Honda WB20XT2 Manual page 53

dummyhead dummyhead
FUEL SYSTEM
FUEL FILTER HOLDER
REMOVAL/INSTALLATION
(A TYPE ONLY)
Remove the fuel filler cap (1).
Turn the fuel filter holder (2) to align it the tether hole (3)
with the cutout (4) of the fuel filler neck, and then
remove the fuel filler cap.
Before installing, check the air vent hole of the fuel filler
cap for clogs. If necessary, clean it using low-pressure
compressed air.
Install the fuel filter holder into the fuel filler neck and
align the cutouts.
Set the fuel filler cap to the fuel filler neck by aligning
the projections (5) of the cap with the cutouts of the fuel
filler neck and fuel filter holder and then turn the fuel
filler cap.
6-4
WB20XT2•WB30XT2
(5)
(3)
(4)
(1)
(2)