Honda WB20XT2 Manual page 59

dummyhead dummyhead
FUEL SYSTEM
CHOKE REPLACEMENT
Remove the carburetor (page 6-6).
Pull out the choke valve plate (1).
Remove the choke shaft (2) and install a new choke
shaft.
Insert a new choke valve plate into the slit (3) of the
choke shaft.
Be sure the choke shaft is in the position between the
projections (4) of the choke valve plate.
CARBURETOR STUD BOLT
REPLACEMENT
Remove the carburetor (page 6-6).
Thread two nuts onto the carburetor stud bolt (1) and
tighten them together, and then use a wrench to turn
the stud bolt out.
Install and tighten new stud bolts until they are fully
seated.
6-10
WB20XT2•WB30XT2
(2)
(2)
(4)
(1)
(1)
(3)
(1)
(2) (4)