Honda WB20XT2 Manual page 80

dummyhead dummyhead
WB20XT2•WB30XT2
Apply grease to the inside of the spring retainer (1).
Apply locking agent (Hondalock 1 or equivalent) to the
threads of the center screw (2).
Set the friction spring (3), friction plate (4), and spring
retainer to the recoil starter pulley in the direction as
shown.
Hold the spring retainer and tighten the center screw to
the specified torque.
TORQUE: 5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
Turn
counterclockwise to preload the starter return spring.
Be sure to hold the recoil starter pulley.
Pass the recoil starter rope (1) through hole (2) of the
recoil starter case, starter grip (3), and reinforcement
grip (4), and then tie the rope as shown. Be sure to hold
the recoil starter pulley (5).
Check the recoil starter operation (page 9-6).
the recoil starter pulley (1) 2 turns
(5)
STARTING SYSTEM
(2)
(2)
(3)
9-5
(1)
(4)
(3)
(1)
(4)
(1)