Honda WB20XT2 Manual page 71

dummyhead dummyhead
IGNITION SYSTEM
OIL LEVEL SWITCH
REMOVAL/INSTALLATION
Disconnect the Oil Alert unit connector.
Remove the camshaft (page 13-4).
Take care not to drop the valve lifter.
NUT (10 mm)
10 N·m (1.0 kgf·m, 7 lbf·ft)
ENGINE STOP SWITCH
REMOVAL/INSTALLATION
Remove the engine stop switch only if necessary for
engine stop switch or fan cover replacement.
Remove the fan cover (page 5-2).
Straighten the tab (1) of the engine stop switch (2) and
remove the engine stop switch.
Install the engine stop switch to the fan cover, aligning
its groove with the boss of the fan cover.
Bend the tab until it is fully seated on the fan cover so
the engine stop switch is held.
The tab is used for ground terminal.
Install the fan cover (page 5-2).
8-6
O-RING
WB20XT2•WB30XT2
OIL LEVEL SWITCH
BOLT (6 x 12 mm) (2)
Align
(1) (2)