Recommended Service Intervals; Record Your Settings; Torque Values - SRAM Rockshox SID Service Manual

R e c o m m e n d e d S e r v i c e I n t e r v a l s
Regular service is required to keep your RockShox product working at peak performance. Follow this maintenance schedule and install the service
parts included in each service kit that corresponds with the Service Hours Interval recommendation below. For spare part kit contents and details,
refer to the RockShox Spare Parts Catalog at www.sram.com/service.
Service Hours Interval
Every ride
Every 50 Hours
Every 200 Hours
R e c o r d Y o u r S e t t i n g s
Use the charts below to record your settings to return your fork to its pre-service settings. Record your service date to track
service intervals.
Service Hours
Date of Service
Interval
50
100
150
200
T o r q u e V a l u e s
Part
Bottom bolts
Top caps
Bottomless Tokens
Race Day Damper rebound nut
Race Day Damper lockout adjuster knob retaining screw
Race Day Damper cable stop collar screw
Race Day Damper spool retaining screw
Charger 2 Damper RL /RL R* retaining screw
Charger 2 Damper RL R* cable stop collar bolt
Charger Damper RL retaining screw
* remote adjust
Maintenance
Clean dirt from upper tubes and
wiper seals.
Perform lower leg service
Perform damper and spring service
Air Pressure
Benefit
Extends wiper seal lifespan
Minimizes damage to upper tubes
Minimizes lower leg contamination
Restores small bump sensitivity
Reduces friction
Extends bushing lifespan
Extends suspension lifespan
Restores small bump sensitivity
Restores damping performance
Rebound setting - count the
number of clicks while turning the
rebound adjuster fully counter-
clockwise.
Tool
5 mm hex bit socket
Top cap/cassette tool or 24 mm
socket
8 mm hex wrench and 24 mm
socket and/or Top Cap/Cassette
tool
10 mm socket
2 mm
2 mm
1.5 or 2 mm
2 mm hex bit socket
2 mm hex bit socket
2.5 mm hex bit socket
Charger Damper Only
Low-speed Compression setting
- count the number of clicks while
turning the compression adjuster
fully counter-clockwise.
Torque
6.8 N·m (60 in-lb)
28 N·m (250 in-lb)
4 N·m (35 in-lb)
4 N.m ( 35 in-lb)
0.3 Nm (3 in-lb)
0.3 Nm (3 in-lb)
0.3 Nm (3 in-lb)
1.4 N.m (12 in-lb)
0.4 N.m (4 in-lb)
1.4 N•m (12 in-lb)

Recommended Service Intervals

6