SRAM Rockshox SID Service Manual page 16

5 Ultimate: Loosen the Ultimate: Loosen the spring side spring side bottom bolt 3 to 4 turns.
Select/Select+: Loosen both bottom bolts 3 to 4 turns. Select/Select+ : Loosen both bottom bolts 3 to 4 turns.
6 Insert a 5 mm extension or hex wrench into the bolt head of the spring Insert a 5 mm extension or hex wrench into the bolt head of the
side side lower leg. Strike the wrench to dislodge the shaft from the lower lower leg. Strike the wrench to dislodge the shaft from the lower
leg. The bolt head should contact the bottom of the lower leg. leg. The bolt head should contact the bottom of the lower leg.
Remove the spring side Remove the spring side bottom bolt. Clean the bolt and set it aside. bottom bolt. Clean the bolt and set it aside.
7
Ultimate: Use a 10 mm socket and extension to remove the rebound Ultimate: Use a 10 mm socket and extension to remove the rebound
nut on the damper side nut on the damper side lower leg. lower leg.
Insert a 5 mm hex wrench into the rebound damper shaft. Strike the Insert a 5 mm hex wrench into the rebound damper shaft. Strike the
wrench to dislodge the shaft from the lower leg. wrench to dislodge the shaft from the lower leg.
Push the shaft into the lower leg. Push the shaft into the lower leg.
Discard the crush washer and rebound nut. Discard the crush washer and rebound nut.
bottom bolt 3 to 4 turns.
spring
Ultimate: 5 mm Spring Side Only
Spring Side: 5 mm & Mallet
Ultimate: 10 mm Damper Side
Ultimate: 5 mm Damper Side
Select / Select +: 5 mm Both Sides
Spring Side
Ultimate: 5 mm Damper Side
16
Lower Leg Removal