SRAM Rockshox SID Service Manual page 35

11 Rapidly push the rebound shaft in and out 15-20 times. Rapidly push the rebound shaft in and out 15-20 times.
12 Compress the damper in a vertical position for five minutes. This will Compress the damper in a vertical position for five minutes. This will
allow the remaining bubbles to float to the top. allow the remaining bubbles to float to the top.
13 Extend the rebound shaft. Extend the rebound shaft.
Remove the bleed screw. Thread a half full syringe into the bleed port. Remove the bleed screw. Thread a half full syringe into the bleed port.
⚠ CAUTI ON - EYE HA ZARD
Oil will eject from the damper assembly if the rebound shaft is
compressed. Wear safety glasses.
14 Push the assembly down to compress the rebound shaft. The syringe Push the assembly down to compress the rebound shaft. The syringe
will fill up. will fill up.
Depress the syringe to inject oil into the damper assembly and allow Depress the syringe to inject oil into the damper assembly and allow
the rebound shaft to fully extend. the rebound shaft to fully extend.
Repeat cycling the fluid 3-4 times. Repeat cycling the fluid 3-4 times.
If bubbles still purge, then repeat step 11-13 until there are no more If bubbles still purge, then repeat step 11-13 until there are no more
bubbles. bubbles.
T10
35
Bleed Procedure