SRAM Rockshox SID Service Manual page 36

15 Push the syringe handle down, then release the plunger. Allow Push the syringe handle down, then release the plunger. Allow
the bladder to come to a natural resting position by waiting a few the bladder to come to a natural resting position by waiting a few
moments until the syringe stops filling. moments until the syringe stops filling.
Use a shop towel to cover the bleed tip and bleed port, then unthread Use a shop towel to cover the bleed tip and bleed port, then unthread
and remove the syringe. and remove the syringe.
Make sure the damper is fully extended and there is a small amount Make sure the damper is fully extended and there is a small amount
of positive pressure in the system before the syringe is removed. This of positive pressure in the system before the syringe is removed. This
prevents air getting back into the damper. prevents air getting back into the damper.
⚠ CAUTI ON - EYE HA ZARD
Oil will eject from the bladder assembly if the bladder is not in its
resting position. Wear safety glasses.
16 Install the bleed screw. Install the bleed screw.
Cycle the rebound shaft a few times. If the damper still feels like it has Cycle the rebound shaft a few times. If the damper still feels like it has
air inside, go back to step 10 and repeat. air inside, go back to step 10 and repeat.
Clean the Charger Race Day Damper assembly. Clean the Charger Race Day Damper assembly.
T10 1·7 N·m (15 in-lb)
36
Bleed Procedure