SRAM Rockshox SID Service Manual page 64

6 Slide the lower leg assembly along the upper tubes until it stops and Slide the lower leg assembly along the upper tubes until it stops and
the spring and damper shafts are visible through the lower leg bolt the spring and damper shafts are visible through the lower leg bolt
holes. holes.
Ultimate: Use a 5 mm wrench to guide the shaft through the damper Ultimate : Use a 5 mm wrench to guide the shaft through the damper
side bolt hole as you install the lower leg. Pull the damper shaft side bolt hole as you install the lower leg. Pull the damper shaft
through the bolt hole so the threads are exposed. through the bolt hole so the threads are exposed.
7 200 hour service only: Use a pick and needle nose pliers to remove 200 hour service only: Use a pick and needle nose pliers to remove
the crush washer from the spring side the crush washer from the
Hold the crush washer with needle nose pliers and unthread the crush Hold the crush washer with needle nose pliers and unthread the crush
washer from the bolt by turning the bolt counter-clockwise with a washer from the bolt by turning the bolt counter-clockwise with a
5 mm hex wrench. 5 mm hex wrench.
Discard and install a new crush washer. Discard and install a new crush washer.
Dirty or damaged crush washers can cause oil to leak from the fork.
spring side bottom bolt. bottom bolt.
NOTI CE
Ultimate: 5 mm
Needle-nose Pliers
Ultimate
Needle-nose Pliers and 5 mm
64
Lower Leg Installation