SRAM Rockshox SID Service Manual page 17

8 Select/Select +: Insert a 5 mm extension or hex wrench into the bolt Select/Select +: Insert a 5 mm extension or hex wrench into the bolt
head of the damper side head of the damper side lower leg. Strike the wrench to dislodge the lower leg. Strike the wrench to dislodge the
shaft from the lower leg. The bolt head should contact the bottom of shaft from the lower leg. The bolt head should contact the bottom of
the lower leg. Remove the damper side the lower leg. Remove the
and set it aside. and set it aside.
9
Firmly pull the lower leg downward until fluid begins to drain. Continue Firmly pull the lower leg downward until fluid begins to drain. Continue
pulling downward to remove the lower leg. pulling downward to remove the lower leg.
If the lower leg does not slide off of the upper tube or if oil does not If the lower leg does not slide off of the upper tube or if oil does not
drain from either side, the press fit of the shaft(s) into the lower leg drain from either side, the press fit of the shaft(s) into the lower leg
may still be engaged. Reinstall the bottom bolts 2 to 3 turns and repeat may still be engaged. Reinstall the bottom bolts 2 to 3 turns and repeat
the previous step. the previous step.
Do not strike the fork arch with any tool when removing the lower leg
as this could damage the lower leg.
50 Hour Service Continue the 50 Hour Service with
200 Hour Service Continue the 200 Hour Service with
damper side bottom bolt. Clean the bolt bottom bolt. Clean the bolt
NOTI CE
Lower Leg
Lower Leg Seal
Select / Select +: 5 mm & Mallet Damper
Side
Service.
Service.
Select / Select +: Damper Side
17
Lower Leg Removal