To 18 Ghz Test-Set Con Guration (Top View) - HP 84125C User Manual

4-2 Test Set Hardware Con gurations
1. Attach the antenna (HP 11966E) to the front plate. Position the
antenna so that the Type N connector on the test set is pointing to
the right of the test set as viewed from the front. Use the 1/4 inch
at washer, the split lock washer, and the 1/4-20 hex nut supplied
in the accessories box, to attach the antenna. See Figure 4-2 below.
Figure 4-2. 1 to 18 GHz Test-Set Con guration (top view)
2. Loosely install the Type N connection of the W3 semirigid cable
to the antenna. The cable will have an SMA (m) to (m) adapter
installed on one end.
3. Select one of the three lters or the through cable and attach it to
the SMA (m) to (m) adapter on the end of the W3 semirigid cable.