Frame Assembly - Rigid Models - Landoll 875 Series Operator's Manual

3-1 FRAME ASSEMBLY - RIGID MODELS

IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
3-1.1 Bolt frame halves together using 5/8-11
x 2 hex head cap screws and hex lock nuts
(See Figure 3-1).
3-1.2 Attach SMV mounting bracket and warn-
ing light bar to rear frame near the center us-
ing 1/2-13 x 5-1/2 hex head cap screw and
hex lock nuts (See Figure 3-1).
3-1.3 Attach SMV emblem to SMV mounting
bracket using 1/4-20 x 1 hex head cap
screws and hex lock nuts.
3-2
Figure 3-1 Frame Assembly - Rigid Models
3-1.4 Place frame assembly on stands ap-
proximately 36" high.
3-1.5 Install mast to frame using coulter sup-
port bars, 5/8-11 x 6 hex head cap screws,
and hex lock nuts.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, ROCK SHAFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THESE PARTS
INTO POSITION.