Table 12: Diagnostic Reports; Table 13: Relay Reports; Table 14: Auto-Function Reports; Relay Reports - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 2.0

Table 12: Diagnostic Reports

Report Selections
R# SDI Dev
Yes, No
∗
Fail
R# SDI Dev
Yes, No
Restl
R# Watchdog Yes, No
Rset
R#
Yes, No
ParaChksmFail
R# Reboot Yes, No
R# Ph Line Yes, No
∗
Fail
R# Ph Line Yes, No
Rstl
∗
R# AC Fail Yes, No
R# AC Restorl Yes, No
R# Batt Yes, No
∗
Missing
R# Battery
Yes, No
∗
Low
R# Battery Rstl Yes, No
R# Rt Comm Yes, No
∗
1
Fail
R# Rt Comm Yes, No
Rstl
R# Checksum
Yes, No
Fail
R# Network Yes, No
2
Fail
R# Network Yes, No
2
Rest
R# Network Yes, No
2
Cond
∗
Indicates an off-normal event.
1
This event covers Comm Fail Route Group and Comm
Fail Phone. If enabled, both events are sent; if disabled,
neither event is sent.
2
This event is reserved for future use.
Bosch Security Systems | 5/05 | F001U003636B
GV2MAIN
Report Description
SDI device failure
Restoral of SDI
device failure
Watchdog Reset
Event
Parameter checksum
failure
Reboot Event
Failure of phone line
Restoral of phone
line after failure
Failure of AC power
to control panel
Restoral of AC
power to control
panel after failure
Battery Missing
Detection Event
Low battery power
Restoral of battery
power to control
panel after Missing or
Low Event
Failure to send report
to specific route
Restoral of
communication to
specific route after a
failure
Checksum Fail Event
Failure of network
Restoral of network
Condition of network
Enable Rt Comm Fail and Rt Comm
Restore in only one route group.
Enable Rt Comm Fail and Rt Comm
Restore in only one route group.

Relay Reports

Selecting Yes enables sending a report when the event
occurs.

Table 13: Relay Reports

Report Selections
R# Sensor Yes, No
Reset
R# Relay Set Yes, No
R# Relay Yes, No
Reset
When activating an on-board relay using
reomte automation software, the
D9412GV2 and D7412GV2 Control
Panels log and print the resulting event as:
Relay 250 (Relay A)
Relay 251 (Relay B)
Relay 252 (Relay C)

AutoFunc Reports

The following prompts support customized routing of
Auto Function Reports. Selecting Yes enables a report
to be sent when the event occurs.

Table 14: Auto-Function Reports

Report Selections
R# Sked Yes, No
Executed
R# Sked
Yes, No
Changed
R# Execute Yes, No
Fail
EN | 18
Report Description
Sensor Reset Event
Relay Set Event
Relay Reset Event
Report Description
Sked Executed Event
Sked Changed Event
Fail to Execute Event