Programming Path Numbers And Ip Addresses For Enhanced Communications; Figure 10: Path # Ip Add1 To Add4; Enhanced Comm; Path # Ip Add1 - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 6.0
6.5 Programming Path Numbers and IP
Addresses for Enhanced
Communications
Enhanced communications is the ability to
communicate by some means other than the standard
digital dialer. In this section, programmable
parameters allow you to define up to four separate
enhanced communication paths to which events can
be routed. To route an event (such as an Alarm or
Trouble) to an enhanced communication path,
additional programming must also be completed in
Section 2.3 Routing on page 13 and Section 2.4 Enhanced
Routing on page 21.

Enhanced Comm

Default: No
Selection: Yes or No
Yes Enable enhanced communications
over the SDI bus.
No Do not enable enhanced
communications over the SDI bus.
Determines if the control panel allows enhanced
communications over the SDI bus.
• Modem Format must be set to Yes
when using enhanced communications.
• Enable Ext Modem must be set to No if
enhanced communications are used.
• Enhanced Comm must be set to No if an
external modem is used.
To disable Enhanced Routing completely
over an SDI path, RG#Primary SDI,
RG#Backup SDI, and Enhanced Comm
prompts must all be set to No.
Events can be routed to as many as four available
paths. If an event (or group of events) is to be routed
to an SDI path, the number entered in Primary Device
determines which SDI path is used (provided that
RG# Prim Primary SDI
,
If events are to be routed to an IP address (in a private
LAN or WAN application), determine which path is
used (Path 1 to Path 4), and enter the appropriate IP
Address for that path (refer to
# IP Add4 ).
If events are to be routed to an SDI Path but not to an
IP Address, allow the setting for
Path # Poll Rate
remain at 0.
Path # Retry Count
Bosch Security Systems | 5/05 | F001U003636B
was set to Yes in Routing).

Path # IP Add1

Path # IP Add#
Path # Ack Wait
,
must be programmed.
GV2AUX
Path # IP Add1
Default:
Selection:
0 to 255
Path # IP Add 1
the IP addresses for each of the four paths available
when using the D5200.
An IP address has four fields. Each field has a range
of 0 to 255. For example, an IP address is expressed as
110.227.64.190. The D5200 programmer splits the IP
address into four programmable fields (refer to Figure
10). Contact your network administrator to determine
exactly where to send IP Address Events.

Figure 10: Path # IP Add1 to Add4

Path # IP Add1

Path # IP Add2

Path # IP Add3

Path # IP Add4

Path # IP Add2
Default:
Selection:
Path 1 IP Add1
Refer to
Path # IP Add3
Default:
Selection:
Path 1 IP Add1
Refer to
Path # IP Add4
Default:
Selection:
Path 1 IP Add1
Refer to
Path
to
to
, and
0
0 to 255
Enter the first three digits of the IP
address. Leading zeros are not
required.
and the next three items determine
110.227.64.190
0
0 to 255
.
0
0 to 255
.
0
0 to 255
.
EN | 127