Remove Internal 3.5-Inch Disks - HP 3000 Series Handbook

For HP Internal Use Only
Remove Internal 3.5-inch Disks
1.
See Figure 8-14.
2. Disconnect the SCSI flat ribbon cable from each disk
3. Disconnect the power connectors from each disk.
4. Remove eight TORX screws and remove the two disks from the disk carrier.
Warning
Do not mix these screws with the system chassis screws or the DDS support
screws. You will damage the disk if you attempt to mount it with the system
chassis screws or the DDS support screws.
Replaceable Parts 8-27