Turn Off System; Chassis Removal Procedures; Remove Front Bezel - HP 3000 Series Handbook

For HP Internal Use Only
Turn Off System
1. Press the On/Off switch to remove DC power from the system.
2. Disconnect the power cord from the wall socket to remove AC power from the system.
Chassis Removal Procedures
The removal procedures are in the order they should be performed. In general, each procedure
assumes that you have performed all of the procedures before it.
Remove Front Bezel
1. See Figure 8-3.
2. Remove two screws from the bottom of the front bezel.
3. Slide the bezel straight up about 0.25 inches.
4. Pull the bottom of the front bezel about one inch away from the system.
5. Lift the bezel away from the system.
8-10 Replaceable Parts