HP 3000 Series Handbook page 185

VALUE
(HEX)
00
04
11
12
15
17
18
20
21
24
25
26
28
29
2A
30
44
45
47
49
88
89
SA
For HP Internal Use Only
Table 5-60. Additional Sense Codes
DESCRIPTION
No additional sense information (NO SENSE).
I
Drive not ready (NOT READY).
Unrecoverable read error (MEDIA ERROR). Unable to recover data with retries or ECC.
Unable to read header of target block (MEDIA ERROR).
Seek operation did not complete within specified time limit (HARDWARE ERROR or
MEDIA ERROR).
Recovered data with read retries, not with ECC (RECOVERED ERROR).
Recovered data with ECC correction, not with retries (RECOVERED ERROR).
Invalid command operation code (ILLEGAL REQUEST).
Illegal logical block address (ILLEGAL REQUEST). Maximum logical block address
exceeded.
Illegal field in CDB (ILLEGAL REQUEST).
Invalid LUN (ILLEGAL REQUEST).
Invalid field in parameter list (ILLEGAL REQUEST).
Media exchanged (UNIT ATTENTION). Tray OPEN/CLOSE operation was executed.
Power-on reset, reset condition, or BUS DEVICE RESET occurred (UNIT ATTENTION).
Block length or error recovery parameter of MODE SELECT command changed (UNIT
ATTENTION).
Incompatible disk in disk tray (MEDIA ERROR).
Internal controller error (HARDWARE ERROR or ABORTED COMMAND).
Select/Reselect failed (HARDWARE ERROR or ABORTED COMMAND).
SCSI Interface parity error (HARDWARE ERROR or ABORTED COMMAND).
Inappropriate/illegal message (HARDWARE ERROR or ABORTED COMMAND).
Object address of an AUDIO TRACK SEARCH command is a data track address
(ILLEGAL REQUEST).
Object address of a READ, SEEK, READ EXTENDED, or SEEK EXTENDED command
is an audio track address (ILLEGAL REQUEST).
The CD-ROM drive is not in continuous audio mode while on an audio track (ILLEGAL
REQUEST).
Troubleshooting 5-81