Internal Peripheral Assembly And Disassembly; Replaceable Assemblies - HP 3000 Series Handbook

For HP Internal
use
Only
Internal Peripheral Assembly and Disassembly
The following sections describe the removal and replacement of the replaceable assemblies of
each of the internal peripherals.
DDS-Format OAT Drive Assembly and Disassembly
This section describes the removal and replacement of the drive replaceable assemblies.
Note
"
• New drives do not include mounting hardware. You must remove the
mounting hardware from the old drive and install it on the new drive.
• Make sure the configuration of the new drive is the same as the old drive
(see Figure 4-12).
Replaceable Assemblies
The DDS drive is normally replaced as an entire assembly. However, the front panel may be
replaced as a subassembly.
8-52 Replaceable Parts