Cmd_Reset Monitor; Restricted Command Set; Tc: Initiate Transfer Of Control; Ta: Initiate Lap Self-Test - HP 3000 Series Handbook

For HP Internal Use Only
If the Non-Activity Timer is disabled (OFF), the Access Port firmware does not monitor the
console input for non-activity.
The default setting for this feature is disabled (OFF).
CMD_RESET Monitor.
When the CMD_RESET Monitor is enabled (ON) and the Access Port
firmware is in the CONTROL mode, the Access Port monitors the bus for RESET. If it is
detected, the Access Port firmware exits the CONTROL mode and goes into the MONITOR
mode.
If the CMD_RESET Monitor is disabled (OFF), the Access Port firmware ignores RESETs on
the bus.
The default setting for this feature is disabled (OFF).
Restricted Command Set.
When the Restricted Command Set is enabled (ON), only the HE,
CO, and SO commands can be executed. Use of any other command results in the error
message Unknown Command.
All commands are available when the Restricted Command Set is disabled (OFF).
The default setting for this feature is disabled (OFF).
TC: Initiate Transfer Of Control
Definition:
This command initiates a system Transfer Of Control by asserting the TOC line connected
to the host's SPU through the support cable. After completion of this command, the AP is
placed in console mode in preparation for rebooting the system.
Valid From: Local Console Port, Remote Modem Port
TA: Initiate lAP Self-Test
Definition:
This command causes the lAP card to execute its self-test. Execution of the self-test does not
alter the configuration or disconnect the modem port if on line. However, any data sent to the
I/0 card during self-test will be lost.
Valid From: Local Console Port, Remote Modem Port
TE: Tell
Definition:
This command treats all displayable characters following the TE command as a comment.
Since characters are echoed to the local console terminal and to the remote console terminal if
it is connected, this has the effect of sending a message to the other terminal. The comment
string, including the command mnemonic, is limited to a maximum of 80 characters.
Valid From: Local Console Port, Remote Modem Port
UR: Unlock Remote Support Modem Access
Definition:
9-12 Functional Description