Cabinet Leveler Or Caster - HP 3000 Series Handbook

For HP Internal Use Only
7. Remove the four (two on each bracket) mounting screws from the PDU mounting brackets
that attach to the frame columns.
8. Lift the PDU up to disengage, the PDU mounting bracket hooks from the frame column.
9. Pull the PDU out of the cabinet.
Note The PDU mounting brackets could be removed at this point if necessary.
"
PDU Replacement:
1. Align the PDU (with the brackets attached) on the right rear column of the cabinet frame.
2. Insert the PDU bracket hooks into the column holes and lower the PDU until it rests on
the column.
3. Insert the PDU mounting screws through the brackets into the column with slip nuts
attached.
4. Route the PDU harness up through the top of the cabinet and through the cable clamps.
5. Plug the PDU harness onto the ON /OFF switch.
6. Replace the top cap (refer to top cap replacement).
7. Reconnect all the cabinet components to the PDU.
8. Plug the power cord into the wall outlet.
9. The cabinet and computer are ready to be powered up.
Cabinet Leveler or Caster
Refer to Figure 8-31 while performing these procedures.
Leveler or Caster Removal:
1. Turn Off the cabinet power switch.
2. Unplug the cabinet power cord from the wall outlet.
3. Carefully move the cabinet to an area with enough room to allow the cabinet to be laid on
its side.
4. Remove all computer components mounted in the cabinet.
5. Carefully lay the cabinet over on one of its sides.
6. unscrew the desired leveler. Or, remove the desired caster by removing four mounting nuts
and pulling the caster off.
Leveler or Caster Replacement:
1.
With the cabinet still on its side, screw in the leveler. Or, place the caster over the four
mounting studs, and attach the four mounting nuts. Tighten the nuts.
2. Carefully lift the cabinet back up to an upright position.
3. Install all computer components that were removed previously.
4. Carefully move the cabinet to its install site.
8-66 Replaceable Parts