Derror Status Codes - HP 3000 Series Handbook

Error
Code
Hex(Dec)
00(0)
01(1)
02(2)
03(3)
04(4)
05(5)
06(6)
07(7)
08(8)
09(9)
OA(10)
OB(11)
OC(12)
OD(13)
OE(14)
OF(15)
10(16)
11(17)
12(18)
13(19)
14(20)
15(21)
16(22)
17(23)
18(24)
19(25)
1A(26)
For HP Internal Use Only
Table 5-50. DERROR Status Codes
Not an error condition.
Reserved.
Reserved.
Timed out waiting for DSP to complete Power On Self-Test.
After power-on, DSP became Command Ready without Finished being asserted.
DSP reported a revision value incompatible with this firmware version.
Power-On DSP RAM test failed.
Parity error on command received.
Reserved.
Reserved.
Received illegal command.
Address of Seek command was outside legal address space.
An attempt was made to set an illegal EEPROM address.
Reserved.
Timed out waiting for EEPROM write to complete.
DSP did not spinup after a spinup command was executed.
Timed out waiting for DSP to become ready for a short term command.
Timed out waiting for DSP to become ready for a long term command.
A Seek was attempted when the spindle was not spun up and locked.
The DSP did not end up in tracking mode after a Recalibrate command was executed.
Bounds test of Track Offset command failed.
A fault is still set after clearing Gate Array fault latches.
Retries were exhausted while trying to verify position during a Recalibrate.
The DC bias adaptation failed to null NPES within the maximum iteration limit.
Maximum iteration limit reached during head alignment SPES null.
DSP sync lost during head alignment SPES measurement.
The drive has entered the Head Alignment Needed state.
5-54 Troubleshooting