Configuration Menu - HP 3000 Series Handbook

For HP Internal Use Only
Processor is starting autoboot process.
To discontinue, press any key within 10 seconds.
When a console key is pressed, the PDC Main menu is displayed.
Main Menu -------------------------------------------------------------
Command Description
BOot [PRIIALTI<path>] Boot from specified path
PAth [PRIIALTICON] [<path>] Display or modify a path
SEArch [DisplayiiPL] [<path>] Search for boot devices
COnfiguration menu
Firmware menu
INformation menu
SERvice menu
Display
HElp [<menu>l<command>]
REset
Displays or sets boot values
Displays firmware information
Displays hardware information
Displays service commands
Redisplay the current menu
Display help for a menu or command
Restart the system
Main Menu: Enter command or menu >
Figure 6-1. Main Menu
At this point, you can enter the BOot PRI or BOot ALT command. When the boot
process is complete, the following prompt is displayed:
ISL>
At this point, type HELP to see which ISL utilities are available.
If you want to run the mini-kernel, type support. The kernel will load, taking several
minutes. The following menu is displayed.
Note
•
ISL> support
If autoboot is not enabled, the sequence of prompts and responses shown
above occurs, with one exception. The first prompt, which allows the primary
boot path to be overridden, does not appear.
5. After a successful boot, the tape is positioned at the beginning of section 1. The login
prompt appears on the System Console. Log in as "root." The password is "support."
After you log in, the support tape Main Menu is displayed on the console.
6-4 Diagnostics and Utilities