Setting The Brightness Of The Dimmer (Composave Mode Or Normal Light); Set Colour Temperature; Turning The Laser Mode On And Off - KaVo LUX 540 LED U Instructions For Use Manual

Instructions for use KaVoLUX 540 LED U / T
6 Operation | 6.1 Operation of the treatment light KaVoLUX 540 LED U
6.1.5 Setting the brightness of the dimmer (COMPOsave
mode or normal light)
Note
The brightness of the light is set in five stages using the "Dim treatment
light" key.
Note
The time it takes for composites to harden is dependent on the brightness or
the effective radiation intensity of the light: The processing time is reduced
with increasing brightness / effective radiation intensity. The processing time
for composites is prolonged with reducing brightness / effective radiation in-
tensity.
▶ Press and hold down the "operating light dimming" button.
ð
Signal buzzes, brightness changes from dark to bright in stages.
▶ Once the desired brightness is reached, release the "operating light dim-
ming" button.

6.1.6 Set colour temperature

Note
The colour temperature of the treatment light KaVoLUX 540 LED U can be set
between five stages with the "X-ray viewer" button in operating mode "Treat-
ment lamp on". The visual perception of the teeth can be adapted or en-
hanced by changing the colour temperature.
4.000 to 4.500 Kelvin: similarity to halogen light
5.500 Kelvin: daylight quality
▶ Press and hold down the "X-ray viewer" button.
ð
Signal buzzes, colour temperature changes.
▶ Release the button when the desired colour temperature is achieved.

6.1.7 Turning the laser mode On and Off

Note
The "laser mode" function is available only from the following version:
- Operating light V1.2.1
- Version of the treatment centre, see: Table Firmware Versions in chapter
4.3.3 KaVoLUX 540 LED U activate in service mode
Older versions must be updated prior to download.
Note
Falsified colour reproduction: the laser mode only possesses a restricted
spectrum output. Therefore a colour comparison should not be carried out in
laser mode.
82 / 110