Setting The Brightness Of The Dimmer; Set Colour Temperature; Turning The Laser Mode On And Off - KaVo LUX 540 LED U Instructions For Use Manual

6 Operation | 6.2 Operation of the treatment light KaVoLUX 540 LED T
▶ Press the "Dim operating light" button once again.
or
▶ Hold your hand in front of the sensor for 2 sec.
ð
The treatment light switches back to normal light mode.

6.2.5 Setting the brightness of the dimmer

Note
The brightness of the light is set in five stages using the "Dim treatment
light" key.
Note
The time it takes for composites to harden is dependent on the brightness or
the effective radiation intensity of the light: The processing time is reduced
with increasing brightness / effective radiation intensity. The processing time
for composites is prolonged with reducing brightness / effective radiation in-
tensity.
▶ Press and hold down the "Dim operating light" button.
ð
Brightness is increased in five stages.
▶ Release the "Dim operating light" button when the desired brightness is
achieved.

6.2.6 Set colour temperature

Note
The colour temperature of the treatment light KaVoLUX 540 LED T can be is
set between five stages with the "Mode/Colour temperature" button. The
visual perception of the teeth can be adapted or enhanced by changing the
colour temperature.
4.000 to 4.500 Kelvin: similarity to halogen light
5.500 Kelvin: daylight quality
▶ Press and hold down the "Mode/colour temperature" button
ð
Colour temperature changes in five steps.
▶ Release the button when the desired colour temperature is achieved.

6.2.7 Turning the laser mode On and Off

Note
The "laser mode" function is available only from the following version:
- Operating light V1.2.1
Older versions must be updated prior to download.
Instructions for use KaVoLUX 540 LED U / T
87 / 110