KaVo LUX 540 LED U Instructions For Use Manual page 36

Instructions for use KaVoLUX 540 LED U / T
4 Assembly | 4.3 Assembly of the KaVoLUX 540 LED U
Switch
E80 SN without 540
100xxxxx LED
with 540
LED
E70 SN without 540
200xxxxx LED
with 540
LED
CAN bus device
Switch
E70 SN 201xxxxx without 540 LED
E80 SN 101xxxxx
with 540 LED
① CAN circuit device / ② CAN circuit patient chair
Setting the CAN circuit device
▶ Select the device type with the serial number from the following table and
adjust the switch setting on the relevant printed circuit board.
Display Unit con-
Controller trol
Assistant
S2 S5
on off**
off off
n. a.* on
n. a.* off
* not available / nicht vorhanden
** with Display Memospeed on the assistant element, this switch must be set
to "on"
Unit control
S5
on
off
* not available / nicht vorhanden
Note
To measure the CAN resistance, the unit must be switched off and the cable
connected.
▶ Switch off the units to measure the CAN resistance.
Dentist KL Elec-
control tronics
S5 SW1
off off
off off
off off
off off
Dentist control
fix (on)
fix (on)
36 / 110
Display KaVoLUX
Controller 540 LED
Dentist
S2
on n. a.*
on fix (on)
on n. a.*
on fix (on)
KaVoLUX 540
LED
n. a.*
fix (on)