Edit Options - Molecular Devices SkanStacker 300 User Manual

Software Configuration
Save Program
Step 1 From Edit Program Menu press the Up arrow key and select Exit/
Save.
Step 2 Press
[Enter]
Step 3 Press Up-arrow key to select Yes-Save at question Save made
changes?
Step 4 Press
[Enter]

Edit Options

When selecting Edit Options from the Setup Main Menu, there are six options
to choose:
Sensor On/Off
Read Sensor
Stacker Sensor (read only)
Set Horizontal Left/Right Position (Set >0< R-mag)
Set Prime/Rinse Left/Right Position (Set >l< P/R)
Test Stacker
Sensor On/Off
The sensors can be enabled or disabled by selecting this option.
Step 1 Press
[Setup]
Step 2 Press Down-arrow key to select Edit Options.
Step 3 Press
[Enter]
Step 4 Select Sensor On/Off by pressing
Step 5 Use Up arrow key to select either Enabled or Disabled.
Step 6 Press
[Enter]
21
.
.
!! IMPORTANT: Program will enter
this save window if user attempts to
exit without saving. If Setup key
pressed to return to the Setup Main
menu without saving, changes will
not be stored in memory.
on the Control Panel to enter the Setup Main Menu.
.
.
.
[Enter]
SkanStacker 300 User Guide