Assembly - Husqvarna P 535HX Operator's Manual

Transport safety
• Use an approved transport
vehicle for transportation of
the product.
• A markets national or local
regulations can set limit to the
transportation of the product.
• The operator of the transport
vehicle is responsible to
attach the product safely
To attach the cutting deck - Combi 155,
R180
Note: Make sure that the cutting deck is put on level
ground before you attach the cutting deck.
1. Put the lever for the hydraulic lifting arms to the
position (B) to lower the lifting arms.
C
B
A
WARNING: Do not put the lever for the
hydraulic lifting arms to the float position
(A). The hydraulic force can cause injury.
2. Carefully move the product into position in front of
the cutting deck.
26

Assembly

D
during transport. Refer to
safely attach the product on a
trailer for transport on page
60 .
Note: To move the product with
the power off, the automatic
parking brake must be
disengaged. Refer to
product on page 61 .
3. Put the lifting arms into the joint of the cutting deck.
4. Apply the parking brake.
5. Turn the power key to the STOP position.
6. Install the bolts (A) and attach the pins (B) on the
lifting arms.
a) For the Combi cutting deck:
A
B
To
To tow the
A
B
1262 - 004 - 04.06.2020