Husqvarna P 535HX Operator's Manual page 27

b) For the R180 cutting deck:
B
A
7. Remove the 2 screws and remove the bottom plate.
8. Pull back the coupling of the drive shaft and attach
the drive shaft to the PTO shaft on the product.
Note: Make sure that the arrow on the symbol points
to the product.
9. Put the rear locking chain around the lifting beam.
10. Attach the locking chain to the drive shaft.
1262 - 004 - 04.06.2020
B
A
11. Pull back the coupling of the drive shaft and attach
the drive shaft to the bevel gear shaft of the cutting
deck.
12. Fold the rubber casing onto the shaft joint.
13. Put the front locking chain around the cross pipe.
14. Attach the front locking chain to the drive shaft.
15. Attach the bottom plate and tighten the screws.
16. Start the electrical drive. Refer to
product on page 33 .
17. Move the lever for the hydraulic lifting arms rearward
to lift the cutting deck. Lift until the pivot wheels of
the cutting deck do not touch the ground.
18. Apply the parking brake.
19. Turn the power key to the STOP position.
20. Attach the lifting eyelets.
a) For the Combi cutting deck: Pull the spring (A)
and attach the lifting eyelets to the cutting deck
(B).
B
To start the
A
27