Husqvarna P 535HX Operator's Manual page 46

To replace the headlights
1. Remove the front cover of the steering column.
To remove and install the front cover of the
Refer to
steering column on page 44 .
2. Remove the 3 screws of the headlights.
3. Remove the headlights.
4. Assemble in opposite sequence.
Fuses
To replace a blade fuse
A broken blade fuse is identified by a burned connector.
1. Pull out the blade fuse from the holder.
2. Replace the broken blade fuse with a new blade fuse
of the same type.
Note: If the blade fuse breaks again a short period after
you replace it, there is a short circuit. Repair the short
circuit before you operate the product again. Let an
approved service agent help you.
To replace a bolt-down fuse
A broken bolt-down fuse is identified by a burned
connector.
1. Turn the main switch to OFF.
WARNING: Make sure that there is no
voltage before you touch the bolt-down
fuse. To touch a bolt-down fuse with
voltage can result in electrical shock and
serious injury.
2. Remove the 2 screws and the bolt down fuse from
the holder.
3. Replace the broken bolt down fuse with a new bolt
down fuse of the same type.
Note: If the bolt-down fuse breaks again a short period
after you replace it, there is a short circuit. Repair the
short circuit before you operate the product again. Let
an approved service agent help you.
46
To replace the fuses in the fuse box
A broken fuse is identified by a burned connector.
1. Remove the service lid. Refer to
sevice lid on page 44 .
2. Remove the cover to the fuse box. Refer to
remove the cover of the fuse box on page 45 .
3. Pull out the fuse from the holder.
4. Replace the broken fuse. Refer to
blade fuse on page 46 .
5. Install the covers.
To replace the fuses of the 48 V electrical
system
You find the fuses of the 48 V electrical system behind
the battery cooling system.
1. Remove the servicing plug. Refer to
install the servicing plug on page 45 .
2. Remove the cover to the battery cooling system.
To remove the cover of the battery cooling
Refer to
system on page 44 .
3. Remove the 2 screws on the top of the battery
cooling system and tilt the battery cooling system
forward.
4. Replace the fuse. Refer to
To replace a blade fuse on page 46 .
and
5. Install the battery cooling system and the cover in
opposite sequence.
To replace the fuses of the 12 V electrical
system
You find the fuses on the side of the 12 V battery.
1. Open the engine cover. Refer to
remove the engine cover on page 45 .
2. Turn the main switch to OFF.
To remove the
To
To replace a
To remove and
Fuse overview on page 6
To open and
1262 - 004 - 04.06.2020