Operation - Husqvarna P 535HX Operator's Manual

4. Engage or disengage the ROPS. Refer to
and disengage the Roll Over Protection Structure
(ROPS) on page 30 .
To engage and disengage the Roll
Over Protection Structure (ROPS)
• Remove the 2 bolts that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in the
opposite sequence.
WARNING: Obey the following
instructions for the ROPS and the seat
belt.
• Do not use the seat belt if the ROPS is disengaged.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Display
Time, language and system menu
When you start the product for the first time, the
language and time menu open automatically. After that
30
To engage
• Always use the seat belt when the ROPS is
engaged.
• Make sure that the ROPS is correctly attached and
not damaged.

Operation

first time, you can get access to the time, language and
system menus through the display.
• Push the time, language and system symbol.
Note: This symbol shows on the display when the
product is stationary for more than 6 seconds.
1262 - 004 - 04.06.2020