Husqvarna P 535HX Operator's Manual page 25

contain carbon
monoxide, an odorless,
poisonous and very
dangerous gas. Do not
use the hybrid drive in
closed spaces or spaces
with not sufficient air
flow, only use the
electrical drive.
WARNING: Read the
warning instructions that
follow before you use the
product.
• For best performance and
safety, do maintenance on
the product regularly as given
in the maintenance schedule.
Maintenance
Refer to
schedule on page 39 .
• Electrical shocks can cause
injuries. Do not touch the
electrical cables when the
main switch is on. For
maintenance on the electrical
cables to the 48 V system,
the servicing plug must be
removed also.
• Do not start the product if the
protective covers are
removed. There is a high risk
of injury caused by moving or
hot parts.
1262 - 004 - 04.06.2020
• Let the product become cool
before you do maintenance
near the engine.
• The blades are sharp and can
cause cuts. Wind protection
around the blades or use
protective gloves when you
do work on the blades.
• Always put the cutting deck in
servicing position to clean it
(applies only to the Combi
cutting decks). Do not park
the product near the edge of
a ditch or slope to get access
to the cutting deck.
CAUTION: Read the
caution instructions that
follow before you use the
product.
• Do not turn over the engine.
• Make sure that all nuts and
bolts are tightened correctly
and that the equipment is in
good condition.
• Do not change the adjustment
of governors. If the engine
speed is too high, the product
components can become
damaged. Refer to
data on page 63 for highest
permitted engine speed.
• The product is approved only
with the equipment supplied
or recommended by the
manufacturer.
Technical
25