Husqvarna P 535HX Operator's Manual page 47

3. Push the snap locks on each side of the fuse cover
and pull out the fuse cover.
4. Replace the fuse. Refer to
fuse on page 46 .
5. Install in the opposite sequence.
To clean and replace the air filter
CAUTION: Do not start the engine when the
air filter is removed.
1. Remove the engine cover.
2. Loosen the 2 latching devices that hold the air filter
cover.
3. Remove the the air filter cover.
4. Remove the air filter cartridge from the filter housing.
5. Clean the inner surface of the air filter housing with a
dry cloth.
1262 - 004 - 04.06.2020
To replace a bolt-down
6. Hit the air filter cartridge carefully against a hard
surface. Replace the air filter if it does not become
clean or if it is damaged.
7. Put the air filter cartridge in its initial position in the
filter housing. Make sure that the air filter cartridge is
correctly installed on the top of the air intake.
8. Install the air filter cover and make sure that the
particle collector points down.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick in the dipstick opening. Do not
tighten it.
6. Pull the dipstick out and read the oil level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Slowly fill the oil through the dipstick opening.
Technical data on page 63 of engine oil
Note: See
recommended. Do not mix different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
47