Husqvarna P 535HX Operator's Manual page 37

4. Move the lever for the auxiliary system forward and
rearward to adjust the cutting height.
Note: The selected cutting height is shown with the
numbers 1-7 on the cutting deck. Refer to the table
below.
5. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
53 .
Number Cutting height, mm/in
1 30/1.2
2 40/1.6
3 52/2
4 64/2.5
5 76/2.3
6 93/3.7
7 112/4.4
To adjust the cutting height - R180
1. Park the product on level ground.
2. Apply the parking brake.
3. Move the lever for the hydraulic lifting arms rearward
to fully lift the cutting deck.
4. Turn the power key to the STOP position.
1262 - 004 - 04.06.2020
5. Remove the locking pin on the adjustment lever for
cutting height.
6. Lift the adjustment lever for cutting height and pull
the lever horizontally. Refer to the table below for
which cutting height that agrees with which number.
7. Attach the locking pin on the adjustment lever for
To
cutting height.
8. Hold the front wheel with 1 hand and remove the
locking pin with the other hand.
9. Move the distance rings up or down, refer to the
table below. The distance rings have 2 thicknesses,
(A) is 15 mm/0.6 in. thick and (B) is 10 mm/0.4 in.
thick.
10. Attach the locking pin on top of the front wheel.
11. Do step 8-10 again with the second wheel.
12. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
55 .
Number Distance rings,
above/below
1 3xA+3xB/0
2 3xA+2xB/1xB
3 3xA+1xB/2xB
4 3xA/3xB
5 2xA/1xA+3xB
6 1xA/2xA+3xB
A
B
Cutting height,
mm/in.
30/1.2
40/1.6
50/2.0
60/2.4
75/3.0
90/3.5
To
37